SD card is pretty straightforward, a single call. This MUST // BE INITIALIZED before using any of the image reader functions! begin() // Initialize screen // The Adafruit_ImageReader constructor call (above, before setup()) // accepts an uninitialized SdFat or FatFileSystem object.
#ARDUINO DELAY FABS NOT DECLARED SERIAL#
While(!Serial) // Wait for Serial Monitor before continuing ImageReturnCode stat // Status from image-reading functions PIN_QSPI_IO0, PIN_QSPI_IO1, PIN_QSPI_IO2, PIN_QSPI_IO3) Īdafruit_FlashTransport_SPI flashTransport(SS, &SPI) Īdafruit_FlashTransport_SPI flashTransport(SS1, &SPI1) Īdafruit_SPIFlash flash(&flashTransport) Īdafruit_ImageReader reader(filesys) // Image-reader, pass in flash filesysĪdafruit_SSD1331 tft = Adafruit_SSD1331(&SPI, TFT_CS, TFT_DC, TFT_RST) Īdafruit_Image img // An image loaded into RAM int32_t width = 0, // BMP image dimensions # if defined(_SAMD51_) || defined(NRF52840_XXAA)Īdafruit_FlashTransport_QSPI flashTransport(PIN_QSPI_SCK, PIN_QSPI_CS, # else // SPI or QSPI flash filesystem (i.e. # define TFT_DC 12 // TFT display/command pinĪdafruit_ImageReader reader(SD) // Image-reader object, pass in SD filesys # define TFT_RST 22 // Or set to -1 and connect to Arduino RESET pin # define WHITE 0xFFFF // TFT display and SD card share the hardware SPI interface, using // 'select' pins for each to identify the active device on the bus. # define USE_SD_CARD // Color definitions # include // Image-reading functions // Comment out the next line to load from SPI/QSPI flash instead of SD card: # include // SD card & FAT filesystem library for Arduino Uno, // MOSI = pin 11, MISO = 12, SCK = 13). As written, this uses the microcontroller's SPI interface for the screen // (not 'bitbang') and must be wired to specific pins (e.g. Requires three BMP files in root directory of SD card: // rgbwheel.bmp, miniwoof.bmp and wales.bmp. Everything was working fine until I typed code for the servo motor ( under if line). I'm using 2 codes combined from 2 different videos.
#ARDUINO DELAY FABS NOT DECLARED HOW TO#
Demonstrates loading images from SD card or flash memory to the screen, // to RAM, and how to query image file dimensions. Arduino - 'setLocked' was not declared in this scope on: October 26, 2017, 05:22:32 pm I'm a beginner in Arduino and I am trying to make a safe using a keypad, lcd and servo. Change the code below by your sketch // Adafruit_ImageReader test for Adafruit ST7735 TFT Breakout for Arduino.
0 kommentar(er)
